P-Square Agencies - Woodturning Supplies Australia
 
 
         
    


Proceed to checkout
 
A - Beverage Accessories Coffee Mug Inserts, Bottle Openers, Bottle Stoppers, etc.
B - Cutlery
C - Pewter & Brass Ware, Pot Pourri Lids, Key Hangers & Card Holders
D - Salt, Pepper, Herb Mills, CrushGrind, S & P Plugs, Shakers & Coffee Kits
E - Dust Bee Gone Masks
F - Pen Kits & Other Kits, Desk Accessories
Abrasives - Fine Micro - Wet & Dry - Pads & Discs
Brass Tubes For Kits
Bullet & Tank Pen Kits
Bushes For Pens & Other Kits
Calendars
Click Pen & Pencil Kits
Crystal Pen Kits
Desk Accessories, Solar Calculators, Pen Trumpets
Junior Gentleman & Graduate Pen Kits
Key Ring Kits
Kit Parts, Centre Bands, Stylus Touch Caps, Twist & Click Mechanisms, Seam Ripper, etc.
Letter Opener Kits
Magnifying Glass Kits
Miscellaneous Pen Kits
Other Kits - Seam Ripper, Chalk Holder, Magnetic Pick Up Kit, Torch Kits, Stylus Kits, Kaleidoscope Kit, etc.
Pen & Pencil Refills
Pen Blank Acrylic Rods 19mm Round x 130mm Long
Pen Blank Acrylic Rods 19mm Round x 300mm Long
Pen Blanks Acrylic Square 19mm x 19mm x 130mm
Pen Blanks Yunstone
Pen Cases, Binders, Pouches & Acrylic Displays
Pen Clips Fancy & Standard
Pen Making Tools
Perfume Kits
Polaris Pen Kits
Razor Kits & Stands
Sierra Tube Based Pen Kits, Lancer, Elegant Beauty
Slimline Pen Kits
Spiritual & ProzX Pen Kits
G - Insert Clocks & Skeleton Clocks
H - Miscellaneous Craft Kits, Jewellery Findings, Key Rings, Candle Cups, Bud Vase Inserts & Parts
I - Hardware - Lazy Susans, Forstner Bits & Bloxygen
J - Souvenir Coins Penny Paper Weight
K - Weather Instruments
L - Ceramic Tiles & Cork
M - Instructions
N - Woodturning & Woodcarving Magazine & Binder GMC Publication

Home : F - Pen Kits & Other Kits, Desk Accessories : Pen Making Tools :

[PEN#2MLC] # 2 Morse Taper Mandrel Saver
enlarge...

[PEN#2MLC] # 2 Morse Taper Mandrel Saver


add to cart
Price: $60.28
Product code: PEN#2MLC

In stock: yes


This #2 live centre can be used with the adjustable pen mandrels listed on our site (PEN#2MTA or PEN#1MTA) just remove the brass nut and reverse the mandrel shaft in the collet chuck sliding it into the morse taper housing. By doing this you wonít be able to damage the thread if itís required for another job. Once you have installed the pen mandrel in the headstock and the live centre in the tailstock slide on your pen blank bring up the live centre, lock the tailstock and apply a moderate amount of pressure, just enough for the pressure to drive the blank and begin turning. If the blank spins just add a little pressure, over tightening can cause problems with the blank and even problems with the mandrel shaft. When turning is complete remove the tailstock and centre, slide off the blank.

 

Copyright © P-Square Agencies. All rights reserved.